For the show

The tools you actually open on a show day.

Open to every Reboot member and free to use, with nothing to install. Built by working techs for the two moments that matter — planning the show, and running it.

Before the show

Design the system, size the power, plan the network and work out who you need on site.

Signal · Data · Power Video Cameras, laptops and media-server outputs through switchers to LED, projection and monitors. Open → Stage I/O · Console · PA Audio Wired and wireless inputs through stageboxes and Dante to FOH, monitors, DSP and amps. Open → Console · DMX · Power Lighting Console and backup through the network and sACN nodes to DMX universes and fixtures. Open → Service · Distro · Circuits Power House power or generator through the company switch and distros to every circuit. Open → Whole-show load Power estimator Total electrical load across video, audio and lighting, balanced across the phases. Open → DHCP · One master Show network Hand your private IP range to every DHCP device from one master. Open → CIDR · VLAN plan Subnet / IP CIDR calculator plus a subnet plan per system — control, video, audio, lighting. Open → Partyline · RF Comms Plan the intercom — who is on which channel, wired against wireless. Open → Leads · Techs · Hands Crew estimator Turn a saved show profile into a crew — leads, techs and hands. Open →

On show day

What you reach for once the gear is in the room.

Cue sheet · Timing Run of show Timed cue list — segments, durations and a cue per department. Open → LTC · Any interface Timecode SMPTE LTC generator out of any audio interface. Open → Pre-doors Redundancy check Kill single points of failure before doors — a backup per discipline. Open → Combined PDF Show packet One deliverable — every builder's diagram plus the run of show. Open →

The Reboot PowerPoint tool joins this list when it is finished.

Everything in one place.

All of these live on the Reboot tools hub.

Open the tools hub →